Help w/Master/Slave problem..
Home | Reviews and Features | Special Reports | Forums |

Results 1 to 5 of 5

Thread: Help w/Master/Slave problem..

  1. #1
    Join Date
    Feb 2001
    Posts
    3

    Help w/Master/Slave problem..

    On most drives i've seen, Master was the right-most set of pegs in the three (i.e ::| )

    but on the DVD-ROM I have, it's the other way around. (i.e |:: )

    It's on the secondary IDE, so I assume the left-most set of pegs is the master. I was just wondering where slave would be on those three sets of pegs.

    [This message has been edited by Argantes (edited 02-05-2001).]

  2. #2
    Join Date
    Mar 1999
    Location
    Canada
    Posts
    89
    It should have it labelled in the back if you look closely. Slave will be labeled SLA.

    ------------------
    PIII 650 @806
    Abit BH6 rev. 1.01
    Diamond Viper 770
    256 MB RAM
    SB Live value
    Olicom 10/100 NIC
    Sigma Designs DVD Decoder
    Matsu****a 5x DVD ROM
    Ricoh 7060A CD/RW
    13.6 gig IBM 14 GXP
    30.7 gig Maxtor DM+ 45
    Athlon XP 1700+@1900+
    Abit KG7
    ATI All-in-Wonder Radeon
    512 MB DDR RAM
    SB Audigy
    Linksys 10/100 NIC
    Pioneer 16x DVD ROM
    Sony 24x10x40 CD/RW
    2x30.7 gig Maxtor DM+ 45 in RAID 0

  3. #3
    Join Date
    Apr 1999
    Location
    Rochester, NY
    Posts
    1,864
    The manufacturers site will usually have a diagram that shows the Master/Slave/CableSelect jumper positions, too.

    ------------------
    Sabres in 6
    "It was a good lay........"

  4. #4
    Join Date
    Apr 2000
    Location
    Karachi, Sindh, PAKISTAN
    Posts
    267
    C the label on the top of drive


    GoodLuck!

  5. #5
    Join Date
    Feb 2001
    Posts
    3
    It wasn't labeled as far as I could tell, I looked pretty close. As for looking for a label on the top, I can't because the DVD-ROM is on the very top, so I couldn't look at it without removing it. I don't know who manufactured the drive either because my whole system was pre-made by Dell

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •