December 8th, 1998, 01:41 PM
old 486 and dual ide controller
I'm trying to get an old 486 board, 30 pin simms, vlb, working with two hard drives and a cd-rom. No matter what I do I can't get two ide ports working. I've tried different controllers, disabling the secondary controller on the vlb, and putting a dedicated ide controller on. No luck. Nothing is working. Is there a limitation on some old motherboards in respect to ide controllers so that the board will not support dual ide?
Any help most appreciated.
All's well that breaks well.
[This message has been edited by krafty (edited 12-08-98).]
December 11th, 1998, 05:52 AM
If you have 2 IDE plugs in your I/O controller, the second one is only for ISA stuff, you could only put there your CR-ROM. You will put both Hd in the first plug, with a two-pin fat cable.
December 14th, 1998, 01:04 AM
don't forget to enable the secondary IDE in your bios! I did the same thing when I installed an LS-120 drive (a great device). I had to enable the secondary IDE port in my AMI bios. Good Luck.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)