cdrom problem
Home | Reviews and Features | Special Reports | Forums |

Results 1 to 3 of 3

Thread: cdrom problem

  1. #1
    Join Date
    Oct 1998
    Location
    NY
    Posts
    16

    cdrom problem

    I am putting together a pc as i described yesterday. I have a HD on IDE1 and i installed the cdrom on ide2 yesterday. i installed the drivers and when i boot(ms-dos 6.2) i get a hard disk failure. when i disconnect the cdrom cable the pc boots with a error that the cdrom is not found which is OK. I cant load win95 without the cdrom.

  2. #2
    Join Date
    Nov 1998
    Location
    Just in Italy
    Posts
    937
    The IDE Cable is backwards. The red line shoul be on the side of the power hook-up. Double check your connection and make sure pin 1 is the red strip, there is usually a notch that will only let it go in one way. If the notch isn't there just make sure Pin1 lines up with Pin1 on the CD-rom.

    Hope it helps
    Michael
    AMD64 3200, 1 Gb Ram, ATI 9800xt(256)
    AMD 2700+, 1Gb Ram, Geforce4600 VIVO
    AMD 2000+, 1 1/8Gb Ram, ATI 8500 (128)
    AMD 1800+, 1Gb Ram, ATI 9600 pro(128)
    Intel 1.6Ghz (478), 768Mb Ram, 8500 (128)

  3. #3
    Join Date
    Nov 1998
    Location
    Atlanta, Ga, USA
    Posts
    118
    the red stripe should be beside the power connection on the hdd and cdrom , the hdd should be primary master and the cdrom should be primary slave on the same cable plugged in to ide1. make sure the red stripe on the cable is plugged in correctly to the board

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •