April 2nd, 2009, 08:41 AM
I am a student looking and have an interest in getting information from my old 1995 Ford. I am in the US.
I can try and download from dialog if you think it may work. Thank you for the help.
April 2nd, 2009, 08:47 AM
I don´t know what is "dialog"
Did you try from opendiag.
I have uploaded it some time ago.
Last edited by Sergio2007; April 2nd, 2009 at 08:51 AM.
April 2nd, 2009, 08:53 AM
I am in the process of trying to verify my account so I have access to the opendiag link you provided above. Thank you.
It looks like there are problems with Yahoo server right now. I will have to try again later.
Last edited by MrTDude; April 2nd, 2009 at 09:01 AM.
April 2nd, 2009, 09:05 AM
Maybe you can suscript some temporal mail to send me by this board.
It is a little complex board for me.
Last edited by Sergio2007; April 2nd, 2009 at 09:14 AM.
April 2nd, 2009, 09:44 AM
I have signed up for opendiag, I'm not sure how long it takes to get access. I will try back later today or tomorrow. I will then try to download you DCL information. Thank you.
April 2nd, 2009, 09:53 AM
In opendiag you have to wait a max time of 7 days, because they process suscriptions once a week.
Best Regards MrTDude.
April 2nd, 2009, 12:03 PM
I was doing more internet searching for DCL information and noticed that you had posted comments on another forum a while back. I have sent an email to the ciudad email address hoping that it is still valid. If ithe address is still in use, can you respond to the email address I sent to you? Thank you.
April 3rd, 2009, 07:31 AM
Send me a comment from my web page and I'll tell you where these are to be found.
April 3rd, 2009, 11:59 AM
I have sent yesterday document to MrTDude.
April 6th, 2009, 11:24 AM
In case you are interested, I've updated my EEC-IV web page to show my progress with DCL. Sorry that there isn't much there yet - I have only been working on this for a few days, but I will post updates as I make progress.
August 27th, 2009, 03:41 PM
Looks like this thread is a few months old, but hopefully you still look at it.
I am wondering if any of you might have the pinout for the 6-pin DLC connector?
From what I have found on the internet I have 1=SIG RET, 2=?, 3=FUEL PUMP, 4=?, 5=STO, and 6=?
From reading this thread it looks like 2 of the 3 unknown pins will be DLC+ and DLC- ?
August 27th, 2009, 09:10 PM
I think that may be this picture can help you
August 27th, 2009, 10:10 PM
That's EXACTLY what I was looking for!! Now I can design some a suite for testing!
Thanks A LOT!
August 28th, 2009, 04:03 AM
Beat me to it! That's time zones for you
August 28th, 2009, 08:18 AM
Well, here is another picture with different polarity in DCL (+) and DCL (-).
May be You will have to test tension levels with a multitester to be sure.
PD: Where are you from flying_greg ??
Last edited by Sergio2007; August 28th, 2009 at 08:24 AM.
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)