ok...now that Ive replaced the sucky GOrb with a hhc-001, it runs rock stable...as this unit is well knowned for its noise, I added in a 60-80mm fan adapter and put on a 80mm enermax thermal probe controlled fan...

Then the comp started crashing again...last BSOD I got was a memory dump error and the temps were 35C on mbm5 and 39C on sandra just b4 crashing...

nothing I did would get the cpu to run stabily...either would not boot or boot to windows and after everything was loaded, bsod again...

I put the delta 60mm fan back and everything was fine even when temps reach 36 in mbm5...weird huh...similiar temps different fan and the cpu reacted differently to it...

could it be caused by the low cfm of the 80mm fan? but the temps were only a tad higher...is it even justified for the system to lock at even 40C? this limit seems a lil low as Ive seen pples systems that run 45 idle...

Just found out that my mobo could only support fsb133-166, so I HAVE to overclock...