October 1st, 2001, 04:57 PM
Cant make cel 533 go in 664
I can make it go really stable in 600 /75 x 8) but not at 83 (664) Why (mb abit be6II)? I tried to increase the volt to (default 2,0) 2,3 (after trying every step between) But it wont work + win2k ****ed up... Any suggestions? ( My temp went up to 50 is that my problem) HELP PLZ.. Normal temp @ 600 is 40
October 3rd, 2001, 04:55 AM
Come on give me some help here dudes
October 3rd, 2001, 05:12 AM
If its not a Celeron II flipchip, Good Luck! If it is a Celeron II or called 533A it should easily run at 800 or even higher! I got one to 896 mhz before. 83 FSB is the worst, it puts your PCI way out of wack, Unless you have super top quality PCI cards, forget 83FSB, If your chip is old .25 micron Mendocino Celeron, the 533 was the last one and they dont overclock good at all.
October 3rd, 2001, 08:05 AM
With a default voltage of 2.0 it's an Original Celeron. Flat-v8 is right, you are doing pretty good to have gotten that chip that far.
I have a 533 CII that will run 992 in my kids comp. We usually only run it at 800 though to keep the PCI bus in spec.
Abit NF7-S Rev2
XP2100+ @ 200x11.5 2300Mhz
512MB Corsair XMS Platnium PC3200 Ultra Low Latency CAS222
Tyan Tachyon G9700 Pro w/Zalman ZM80a-HP Heatpipe
Turtle Beach Santa Cruz
"Fat, Drunk and Stupied is now way to go threw life Son!" Quote: Dean Wormer.... Animal House
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)