I got some of the of the nice stuff on the wires that connect the cache, on a classic Athlon, to its pc board. Its crammed in there and a Q-tip doesnt get it all out. Can this cause damage from a short circut or bridging ???
Also: This one is a Classic 600 0.25 Micron. I'm using the "Tweaking Device". Having bad luck so far...will I ever get anywhere with the 1/2 speed level 2 ???
------------------
"I cant drive...55 !!!"
[This message has been edited by DoctorFoxx (edited 09-10-2000).]
It contains silver, but in oxidized form. Luckily for you, silver-oxide is non-conductive According to the manufacturer, Artic Silver isn't conductive and can be used in close proximity to electronics without fear of squishing a little bit out onto them.
Actually Arctic Silver is pure micronized silver, not silver oxide. The non-conductivity is due to the suspension characteristics and coating properties of the special carrier.
Still, with all the dust and contaminants that swirl around inside a computer, it is best to keep any sticky substance off of cache chip and processor leads.
Usually a toothbrush and isopropyl alcohol will be successful in getting the compound out of tight places where it does not belong.
Thanx, I will try the toothbrush...seems logical. I was actually using a Q-Tip to wipe it off on the edge of the cache when I accidently "Smeared" it in to the "Centipede Legs".
Its been an experience. The stock unit wouldn't cool it and the new GORB wouldn't fit. I drilled new holes and mounted it up somewhat so it cleared the power connector and stuck 2 extra fans on it. Its cool now, but the errors are constant at stock speed.
I wonder if that Artic Silver works on a headache ?
------------------
"I cant drive...55 !!!"
[This message has been edited by DoctorFoxx (edited 09-11-2000).]
I used a toothbrush and alcohol. I actually cleaned the whole damn thing, with the TechTV commercial playing in the background. Low and Behold Arnie..." No Problemo " !!!
Bookmarks