I AM PISSED OFF!!!!!!

[zodder]

I just got the nerve to put this damn peltier together. It's potted perfectly, the foam is cut nicely and the pelt and cold plate are on. I go to screw the fscking thing together and the screws are too short!! It won't screw into my alpha because it's too damn thick! If I didn't have this Cel333 in my other machine, I'd be screwed. WTF do I do now? I'm raging!!

[Machupo]

go to Bishop's tomorrow morning?

------------------
.model small

.DATA
**strBooYah db '600e@930',0dh,0ah,$

.CODE
start:
**mov dx, offset strBooYah
**mov ah, 09h
**int 21h
exit:
**mov ah, 4ch
**int 21h

END

[zodder]

What's bishops? Do they sell screws at compusa or any other store? Can I get them online somewhere?

[Hobbesk]

Best bet is to take one of the screws to a hardware store, and get a same size/thread screw that is just the length you need. Now don't get it too long or you'll never get the seal tight.

[gunk]

Originally posted by zodder:
What's bishops?

I think hes talking about church. Wait, is it saturday where you are? i thought churches only open on sundays...

[Machupo]

zodder, bishops is a hardware store... they sell everything... there are three right near my place... and i'm not too far from you (1.5 hrs. or so)... daum, jopey's right next door to ya

well, hope you get your ducks in a row

------------------
.model small

.DATA
**strBooYah db '600e@930',0dh,0ah,$

.CODE
start:
**mov dx, offset strBooYah
**mov ah, 09h
**int 21h
exit:
**mov ah, 4ch
**int 21h

END

[zodder]

I have been to 2 huge hardware stores and can't find the right screws. This sucks.

[Big Lar]

Try the metric size screws.... Most ace hardware stores have them, Hope you find em soon

------------------
Help me get this Boot outta my azz!!!!