Over clocked or not

[Fraekazoid]

Hello , I need help determining wether or not I can overclock my cpu or if it might already be overclocked. This is what I see on start up Am5x86-P75-5 cpu at 133 mhz.If I can I would like to make my cpu go faster. If more info is required just let me know I am new at this so I must be told, and please take it easy on me. Thanks for any help

[Fraekazoid]

OOPS made a mistake that should be am5x86-P75-S cpu at 133 mhz and also have co-processor installed whatever that means

[Quatroux]

That's the math co-processor. On the pre-pentium chips they had a seperate processor (ususall TI) that did a bit of the math operations for the chip.
Do you know what type of motherboard you have?

------------------
www.quatroux.8k.com

[This message has been edited by Quatroux (edited 07-22-2000).]

[Fraekazoid]

Hm I am not sure I have opened the case and was not able to find any tags or numbers, but during start up I see something about miatech hope that helps or if you know of a proggie that I can use to tell me I am all ears. Thanks

[TNproud2b]

Install SiSoft SANDRA> http://www.overclockers-network.com/...ads/san600.zip and then click on 'mainboard information'.

[Fraekazoid]

Thanks again for all the help.Here is what i gather from SiSoft under main board Manufacturer Mitac, Model MiTAC International Corp. PH4500AuBios R1.05,Serial # 11/14/95-UMC-881/886H-2A4x5M32C-00. I hope this is what you all needed.