Iwill Slocket II ... i need a picture of it

[#Rotor]

Or even better a .PDF that will give me all the dimensions. the picture as high resolution as possible, as I'm proly going to end up using my ruler on the screen to get the dimensions , and from the top. a side view would be handy too.

thanks in advance....

[XkALiBRe]

I dont have a digital cam at the moment, but I do have a Slocket II. If you tell me precisely what measurements you need, and in what units you'd like them, I'd be happy to whip it out, and measure it for ya.

------------------
"In the computer industry, there are three kinds of lies;
lies, damn lies, and benchmarks."

[This message has been edited by XkALiBRe (edited 04-17-2000).]

[#Rotor]

well every thing actually

I'm busy designing a h²O-block for Deveg's Chip-Chiller. he is going to use a Iwill II slocket, he had sent me an picture already, with some info on it,
http://24.68.81.76/images/iwill-slocket-ii2beta.jpg

I'm ACAD'ing it and need to be as accurate as possible

[daveg]

Just bringing it back to the top.

I haven't had any luck finding a side view picture.

If anyone here has a digital camera and Iwill slocket II could you post or email me or rotor a picture.

daveg@thehouse75.freeserve.co.uk

[tknojnky]

I have the Iwill, and a really good camara! Give me a couple hours and I'll see what i can do...

[Toolbox]

I replied to this in the General Forum already.

[daveg]

We need a picture because Rotor is making me a water block. Those big capacitors might be a problem. Most of the pictures I've found on the web don't clearly show the height of the capacitors relative to the height of the cpu.

[Terry]

I saw an article somewhere about a month ago where the guy unsoldered the capacitors and put em on the BACK of the board. All kinds of clearance then.

[#Rotor]

Thanks toolbox

------------------
Go ahead...... lick my BLOCK
My page is here now.