I installed Peltier finally today. BUT, I almost burned my finger trying to detec which side is hot/cold! It's damn hot! Also, I had a tough time sealing it from air using silicon sealant... it's got so messy. When I installed it, it gets a window protection error! What the hell.... w/o peltier it works fine again. What did I do wrong here? I noticed how HOT it gets on ALPHA heatsink. I think I better stick with alpha heatsink. It is still rock stable. I was thinking about oc'ing close to 525MHZ w/ peltier. I think I should keep it for future comp.
ps: surprisingly, CPU does not get hot at 500MHZ 2.6v even after hours of usage...? I guess alpha heatsink along with 2 60mm fans(one sucking one blowing from side) work well....
[This message has been edited by Tim Lee (edited 08-14-99).]
PC133 128MB ECC
WD SCSI2 10K 5.2ms 18.3G
Vortex2 w/ digital out
Sony MHC-5500 Digital Signal Processer - 30 equalizers and Dynamic Sound