got a p3 450...disabled error hold and it started to load windows..but window looked grainy and froze(o/c it to the minumum 4.5 x 112)...need help..i dont have any heatsinks or fan only the one that came attached with the p3 chip...do u think that is the reason why its not working??can someone help??
Before you try a voltage increase try 124Mhz. Set the AGP to 2/3 and disable speed error hold. If your ram will run at that speed you will prob be OK. Very few PIII450 will not run 558MHz @ 2.0V. The pherp. normally will give problems running at some bus speeds.