A free service rounding up the week's news, articles, tips and reviews.







Build Your Own PC

Install Video Card



May 31, 1999
By David Risley

This is an easy step. It covers ISA, VLB, and PCI cards. Information on AGP can be found here.
Related Articles

  • Find an expansion slot ideal for your Video Card. The slot must be the correct type, and it should be as far as possible form other hardware in the system.
  • Remove the case insert that corresponds to the slot on the motherboard. This is usually done by unscrewing, but some cases have punch out inserts.
  • Insert the Video Card in the slot. You might need to rock the card in, inserting one end first, then rocking the rest of the pins into place. The old ISA cards may be tougher because of their length. You might not be able to rock them. When pushing down, make sure the motherboard does not flex. It may be necessary to place one hand underneath the board to hold it up.
  • Screw the card into place.
  • Double check your work.
Previous: « Connect CD-ROM Next: Post-Assembly »

Skip To Page
1 Introduction
2 Purchase/Collect Components
3 Remove System Case
4 Prepare Case
5 Install Floppy Drive
6 Configure Hard Drive & CD-ROM
7 Install Hard Drive
8 Install CD-ROM
9 Configure the Motherboard
10 Install the CPU
11 Install Heat Sink
12 Install Cache Module
13 Install Memory
14 Install Motherboard
15 Install I/O Port Connectors
16 Connect the Motherboard to the Case
17 Connect Floppy to Motherboard
18 Connect Hard Drive
19 Connect CD-ROM
20 Install Video Card
21 Post-Assembly
22 Initial Boot-Up
23 Configure the BIOS
24 Test Your System
25 Install Additional Hardware
26 Prepare the Hard Drive
27 Install Drivers and OS


 
  Topic By Replies Updated
Toolless 8
marei 6
YankeeMan 1
detailer 7
zillah 2
sbrown121 4
saiadmiah 1
stevebreslin 12
grasshopper1970 3
RWaytz 1

 
  Topic By Replies Updated
Toolless 8
detailer 7
marei 6
YankeeMan 1
 


Linux is a trademark of Linus Torvalds.