Hi fellows,
This is my first post in this board.
I´m senior member on the AMDZone forum and
this board is kicking asses...
I´m building my first watercooled peltier
rig and my open question is:
What are using to prevent condensation ?
Is there anyone using the hot-wire method ?
(a wire wrapped around near the SLOT-1/A edge connector, with DC applied, generating some heat and thus preventing the cold to pass to the slot, preventing condesation)
I havent heard about anybody doing this... but then again I'm not an expert. I just thought I'd respond to your post since no one else did. I think most other people are just trying to keep air away from the parts, but like I said I'm not sure...
