Printable View
Hi everyone, I am just about to get an ABIT BP6 (dual-celery), and I was just wondering how good are they on overclocking, (sounds like a dumb Q,since it has Softmenu II™ and separate voltage settings for each processor but I would like to hear from ppl's experience overclocking it.) I'm gonna put 466 celerys on it, Could it do a 550 easily?
I can't speak personaly about the BP6, but I understand set-up wise it is same as other Abit boards..
I would not expect more than 525 from 466 though... (FSB = 75).. the 7 multiplier on the 466 is a bottleneck..
7 x 83 (581) and 7 x 100 (700) are pretty unrealistic..
If you want to do 550, get a couple of the pretested 366's... They are going for about the same price as a retail 466...
[This message has been edited by Diogenes (edited 09-21-99).]
Go with the 366 Celerons and run them at 550 MHz. Generally if they are Malay week 21 or better they will run at 550 MHz @ 2.0 volts. I have two on a BP6, a week 27 and a week 32, both run solid at 550 MHz@2.0 volts.
I have 2 466 Celerons and both do 602 MHz and boot into Win98SE but will not boot into W2K or NT4 at above 525, any ideas??
P.S. Chips are stable @602 i.e. runs Prime95 RC5 and Unreal Tournament
[This message has been edited by Josidiah (edited 10-21-99).]
